42mm 3Phase Hall Sensor Brushless DC Motor Driver, 24VDC Speed
Controller 2-Quadrant PI close-loop Speed Driver
Features:
1. Surface-mount Technology and small size.
2. 2-Quadrant PI Closed-loop control of speed with good linearity.
3. Variable Parameter settings for different motors
4. Control functions of F/R, enable, speed reference and output
functions of speed pulse(PG), alarm. Over temperature protection.
5. Three kinds of reference inputs: analog voltage, PWM, Frequency.
6. Suitable for 3-phase BLDC motors with hall sensors.
7. Use of industrial grade chips.
Model and Specification:
N series 2-Quadrant BLDC Motor Speed Driver:
| Model | Voltage
| I peak (A) | I cont (A) | Po (W) | Reference Input | Size (mm) |
| BLSD2410DC-2Q-N | 24VDC
(17~32V)
| 10 | 5 | 120 | 0~10v/ PWM/ Frequency
| W82.5,L162,H29 |
| BLSD2420DC-2Q-N | 20 | 10 | 240 |
| BLSD2430DC-2Q-N | 30 | 15 | 360 |
Driver Numbering Information:
BLSD 12 10 DC -2Q-N-T
BLSD: BLDC Speed Driver
12: Rated Voltage(VDC)
10: Peak Current Limit(A)
DC: DC Power supply
2Q: 2-Quadrant Driving Mode
N: N series(normal size and variable parameters)
T : -40~+65℃ Ta, Unlabelled=-10~+45℃ Ta
Notice:
1.Select peak current of driver: Ip(A)≧2*Ir(A) or Ip(A)≧4*Pom/(1.414*Vp), Irm=rated current of motor(A) Pom=Rated output
power of motor(W), Vp=AC supply voltage of Driver(Vrms)
2. Driving quadrant: The drivers are only used in I&III quadrant.
3. Interference from leads: The Hall signals can be disturbed by switched current in windings
leads when length is more than 3m. Don't intertwine them together.
It is better to use shielded leads.
4. Motor Insultaion: Hall sensors to Windings/Hall sensors to Motor Cse/Windings to
Motor Case
Insulation Resistance＞100MOhm@1500VDC
Dielectric strength＜1mA@1200VAC/50-60Hz/1 minute
5.Safety: The PE terminal labeled on the driver must be connected to the
protection earth point of the supply system.
Typical connections:
BLDC Driver Inter face Port Descritpion:
Mechanical Size:
Picture Details:
